BLOG

Protected vs unprotected 18650 batteries: which do you need?

Short answer. A protected 18650 is a bare cell with a small protection circuit added. The circuit disconnects the cell if it is over-charged, over-discharged or short-circuited. Use protected cells in single-cell devices that ask for them, such as many flashlights. Use unprotected (bare) cells in battery packs that have their own battery management system (BMS) and in devices with protection built in.

WHAT A PROTECTED CELL ADDS
CELLTHE BARE 18650 FROM THE MAKER
+ CIRCUITA SMALL BOARD ON THE NEGATIVE END
+ STRIPLINKS THE BOARD TO THE POSITIVE END
+ WRAPA NEW OUTER WRAP, OFTEN WITH A BUTTON TOP
A protected cell is a bare cell with a small circuit board, a connecting strip and a new wrap.

What the circuit does

  • Stops the charge if the voltage goes too high.
  • Stops the discharge if the voltage goes too low.
  • Cuts the current on a short circuit or an overload.

The trip points belong to the circuit, not to the cell maker's data sheet. Where the circuit maker does not publish them, our product page says “Not stated by manufacturer”.

What changes when a cell is protected

PROTECTED UNPROTECTED
Built from A bare cell plus a circuit board, a connecting strip and a new wrap The cell as the maker ships it
Length Longer than the bare cell The data-sheet size, for example Ø18.55 × 65.25 mm maximum for the Samsung INR18650-35E
Positive end Usually a button top Usually a flat top
Use it for Single-cell devices that specify protected cells Packs with a BMS, tools and devices with protection built in
Watch for Fit, and a circuit limit below what the device draws No cut-off at cell level: the device or pack must provide it

The cell inside keeps its data-sheet ratings. A protected Samsung INR18650-35E is still a 3,350 mAh minimum cell (0.2C to 2.65 V, 23 °C) rated for 8 A maximum continuous discharge.

Samsung INR18650-35E bare 18650 cellsSamsung INR18650-35E protected button-top 18650 cell
Samsung INR18650-35E as a bare cell and as a protected button-top build.

Common questions

Are unprotected 18650 batteries dangerous?

An unprotected cell has no electronics to stop misuse. It is the normal choice inside packs and tools, where the BMS does that job. Keep bare cells in a case with the wrap intact, never loose in a pocket or bag, and read our battery safety page.

Can I build a pack from protected cells?

Use bare cells with a BMS. Individual protection circuits add length and resistance, and they are not designed to work together in series or parallel strings.

How do I tell which one I have?

A protected cell is longer than 65 mm and usually shows a thin strip under the wrap and a plate on the negative end. Our product pages state the build: bare cell, button top added, or PCB protected.

Sources

Samsung INR18650-35E data sheet for size, capacity and current, linked from the product pages. Browse protected and button-top 18650 cells or all 18650 cells.

MORE FROM THE BLOG

Keep reading

ALL POSTS